When cutting and the file cuts too large or too small...
It's a pretty simple fix within VectorCUT 2.0
When setting up the Graphtec CE6000 cutter, if the cutter language on the cutter is set to HPGL, the stepping setting in VectorCUT/Properties/Command Tab is normally set to 0.025. If the language is set to GPGL, the stepping setting would be set to 0.100.
So, if you are experiencing the cut size issue, test each language with each Stepping setting. GPGL (0.100 & 0.025) HPGL (0.100 & 0.025)
To test the size issue on the cutter... create a square shape file 2" high by 2" wide. Cut the file then measure the shape. Obviously it should match, but if it is off, it will normally be in equal increments. 1/4", 1/2", 1" etc... So if file is 2" but cutting at 1/4", set the Stepping to 0.025. (Normally the setting will be set to either 0.100 or 0.025)
Easily put, the lower the Stepping setting, the larger the file will cut. Kind of just the opposite way of thinking for some.
